| Step | | Procedure & Parts & Tools |
| 1 |
|
Drop the deck.
|
| 2 |
|
Locate the switch by looking though the square hole in the right side of the frame. Switch should be free to move up and down.
|
| 3 |
|
View from underneath. Switches stuck in the up position will prevent the brushes from turning.
|
| 4 |
|
Open tank and locate the wires coming out of the end of the switch. Note the orientation of the wires and the location of the plug-in at the Power Board. If the wires are disconnected...the brushes will spin, even when the deck is raised.
|
| 5 |
|
Unplug the wires from the Power Board. Using a multimeter set for "Continuity", probe the white plug as you push the switch in with your fingers. A working switch will "beep" when pressed in.
| Volt meter (True RMS capable) |
&Width=100)
|
|